YG1 83595TN 5/8″ Size, 7/8″ LOC, 3 Flute, TiN Solid Carbide Finishing End Mill Best Choice

Applications

The YG1 83595TN end mill, sized at 5/8″ diameter with a 7/8″ length of cut, is designed for finishing operations requiring both rigidity and precision at a moderate reach. Its length-to-diameter ratio of approximately 1.4 supports stable cuts in non-ferrous materials. Equipped with 3 flutes, a 50° helix angle, and TiN coating, it minimizes built-up edge and enhances chip evacuation, particularly in aluminum alloys such as 6061 and 6082. This configuration delivers clean surface finishes during wall and floor machining tasks. However, it should not be used on heat-resistant superalloys (HRSA ISO S) due to the TiN coatings unsuitability and rapid degradation. The lack of a corner radius places importance on the tool’s geometry and coating to prevent chipping, optimized for smooth, continuous cutting in non-ferrous metals and certain steels and cast irons.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The high rake angle and 50 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.