YG1 83907TC 5/8″ Size, 2-1/2″ LOC, 3 Flute, TiCN Solid Carbide Finishing End Mill Popular

Applications

The YG1 83907TC solid carbide finishing end mill, sized at 5/8″ diameter with a 2-1/2″ length of cut and 3 flutes, provides a suitable balance of rigidity and reach for precision finishing on non-ferrous materials. Its 50° helix angle paired with a TiCN coating improves chip evacuation and reduces friction, resulting in clean cuts with minimal built-up edge, particularly in aluminum alloys like 6061 and 6082. This tools design and coating synergy enhance surface finish and extend tool life in non-ferrous applications. The single-end, center-cutting geometry allows for plunge cuts and slotting with controlled chip flow. Without a corner radius, it is optimized for sharp edge precision rather than interrupted cuts where chipping resistance is needed, favoring fine finishing over heavy roughing. Avoid use on heat-resistant superalloys (HRSA ISO S) as the coating is not ideal and will degrade performance. While capable of machining steel and cast iron, these applications are secondary and may not fully benefit from the coatings attributes.

Features

• Designed to machine stainless steel, inconel, titanium and other hard to machine materials.
• It’s 3 flute design gives high stability and allows good chip removal in plunging & slotting operations.
• The high rake angle and 50 degree medium helix allows an extremely wide range of application.
• YG:TYLON super TiAlN coating are recommended for maximum performance.